Technol 403 is a proprietary, premium performance , scientifically formulated multipurpose distillate and diesel fuel improver.

Technol 403 does not contain harmful alcohols, acids, salts, heavy metals or Barium

• Formula: proprietary
• Material is: liquid
• Boiling Point : <300º F
• Vapor Density: >1
• Appearance: amber liquid
• Specific Gravity: 0.9
• Vapor Pressure (mmHg@20ºC): <5
• Solubility in Water: Negligible
• Evaporation Rate (Butyl Acetate=1): <1
• Unusual Chronic Toxicity: none known
• Flash Point: 135ºF Open Cup
• Unusual Fire/Explosive Hazards: none known
• Stability: product is stable
• Conditions to Avoid: Excessive heat, decomposition can occur @ 350ºF
• Incompatibility: Strong oxidizing agents. Potential dangerous reaction with strong acids or bases. DO NOT store in rubber or rubber lined container.
• Hazardous Ingredients: This material is NOT known to contain any of the carcinogens listed under the OSHA Communication Standard 29CFR 1910 1200.

Economical: Technol 403 is economical to use...costing as little as 3 cents per gallon, it turns low grade diesel into a premium grade.

• Cetane Improver: Can improve cetane by up to 6 numbers. This is particularly important if the fuel being treated meets only the minimum standards for diesel fuel. Fuels with higher cetane ignite sooner and produce a low rate of pressure rise and low peak cylinder pressures resulting in smoother performance, reduced engine wear, reduced engine knock and reduced exhaust emissions, especially smoke and carbon emissions. At slow engine speeds, engine misfire is reduced or eliminated. Increasing cetane also results in overall improvement in engine performance and increased fuel efficiency and will reduce or eliminate carbon build up on injector nozzles and prevent further carbon formation.
• Increased Fuel Lubricity: With the introduction of lower sulphur fuel, engine manufacturers have reported accelerated damage to and leakage in fuel injection pumps and other components of the fuel system due to reduced fuel lubricity. Technol 403 increases fuel lubricity by up to 12 1/2% (BOCLE Test) protecting these expensive components from the effects of the low sulphur fuels.
• Controls Water: Algae requires water in its environment in order to flourish. Technol 403 controls waters' harmful effects in two ways: 1. Provides solvents that dissolve water up to 200 ppm (parts per million) 2. For water over 200 ppm, provides powerful demulsifies that reject any excess water to the tank bottom for removal.
• Disperses Sludge: Technol 403 has the ability to disperse and eliminate dirt and sludge, a byproduct of algae growth--a biocide cannot do this, and Technol 403 is not a hazardous material.
• Decreases Exhaust Smoke: The ingredients in Technol 403 reduce exhaust smoke in two ways. The cetane improver results in cleaner injectors, pumps & fuel lines which improves burning and contributes to reduced smoke. The ingredients that disperse water and sludge also help to reduce the amount of exhaust smoke, The result is a noticeable reduction or elimination of grimy deposits on transoms and unpleasant orders while underway.

For best results, the fuel tank should be relatively clean. If you suspect a dirty tank, have your tank professionally cleaned prior to using Technol 403. For best mixing with fuel, add Technol 403 before tank fill-up. Acceptable treatment ratio range from 1:500 to 1:4000. The recommended treatment ratio is:

Initial Treatment: 1:1000  |  Subsequent Treatments: 1:2000